...
Code Block |
---|
$[enter] $[no-enter] |
These modifiers have to be put at the end of the line, and control if Enter <Enter> will be sent after the command line.
The default behavior is to send enter, UNLESS "$[no-enter]" is specified, or the command is a control sequence.
(please check the Command parsing examples section for more details)
Unimus supports sending various control sequences to the device, in this format:
Code Block |
---|
$[0x01] |
As mentioned above, Enter <Enter> is not by default sent after a control sequence, but this can be forced by appending "$[enter]" to the end of the line.
Full list of command sequences available in this article: VT100 Control / Command sequences.
...
Code Block | ||
---|---|---|
| ||
\$[0x01] = "$[0x01]" will be sent literally \$[enter] = "$[enter]" will be sent literally |
Please check the Command parsing examples section for more details on how modifiers and control sequences work.
How commands are sent to devices
...