Table of Contents |
---|
Basics
Mass Config Push in Unimus is used to send a set of commands to to a group (or all) of devices in your network. This allows you to roll out mass config changes across your network, or query command outputs from a large set of devices. Before you can push to devices, each device must be in a "discovered" state (normally done one device addition into Unimus). Config push will not be performed to undiscovered devices, and they will be grouped in the "Un-discovered devices" group.
...
The commands you specify in the Push Preset are sent to the devices, one line at a time (more info in How commands are sent to devices).
State of device before Push - require "enable" or "configure" CLI mode
...