Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 12 Next »


Mass Config Push in Unimus is used to send a set of commands to to a group (or all) of devices in your network. This allows you to roll out mass config changes across your network, or query command outputs from a large set of devices. Before you can push to devices, each device must be in a "discovered" state (normally done one device addition into Unimus). Config push will not be performed to undiscovered devices, and they will be grouped in the "Un-discovered devices" group.

To perform a push, you first need to create a "Push Preset" from the Mass Config Push home page. After a preset is created, you can click  "Run now" to push the provided commands to the selected devices.

Output Grouping

The commands you specify in the Push Preset are sent to the devices, one line at a time (more info on how Unimus interacts with the device in How commands are sent to devices). The outputs of the executed commands are evaluated on all devices, and a new "Output Group" is created for each unique output during the push. If 2 devices reply with the same output, both devices are assigned to a single output group belonging to that unique output.

As an example, if you push a command to 200 devices, but across all devices there will only be 2 unique outputs to this command, Unimus will create only 2 output groups, and assign each device to the right output group. Output grouping means you don't need to inspect outputs of 200 devices after a config push - saving you time, and making navigation in large push outputs easy.

State of device before Push - require "enable" or "configure" CLI mode

You have the option of letting Unimus ensure that each device in the Push Preset is in a desired CLI mode before your specified commands are pushed. You can check "Require enable mode" and/or "Require configure mode" in the Push Preset, and Unimus will make sure the device is in the specified mode before executing your commands. Modes available on devices are discovered during Discovery, using mode credentials configured in the "Credentials" screen. You can check which modes Unimus was able to discover on devices using the "Devices > Info" window.

If a device can not be switched into the specified CLI mode before, Config Push will NOT push the provided commands to the device, and any devices failing the mode switch will be grouped in appropriate "mode not supported" output groups.

The "enable" and "configure" mode names are only symbolic - each device type has their own modes. In general, the "enable" mode means the 2nd highest possible CLI mode on the device, and the "configure" mode the 3rd highest possible CLI mode on the device (if the device type supports this). Taking Cisco as an example, the "user exec" mode would be 1st possible login mode, "privilege exec" would be the 2nd (enable) mode, and "configure mode" would be the 3rd (configure). Please see our

Command parsing

Command sending modifiers and control sequences

How commands are sent to devices

Config Push in Unimus has a few stages:

  • connect to device, login to the CLI
  • switch the device to desired CLI mode (if require "enable" or "configure" mode is set)
  • send each command line from the "Commands" to the device (more info below)
  • collect all output from device
  • disconnect the CLI session
  • create a new output group for this device OR assign the device into an existing output group

The main (and most important) portion of this

Command parsing examples

Debugging failed pushes - "INTERACTION_ERROR" group

  • No labels